Skip to content

Manufacturing

Metal Weight Calculator

Part weight and surface area for metal and plastic stock.

Metal weight & surface area

Weight and total surface area of a plate or round bar in common metals and plastics.

Work out the weight and total surface area of plate, flat bar and round bar in steel, stainless, aluminum, brass, copper and plastic, for quoting material, shipping and coating.

Free to use, no signup needed. Calculations run in your browser.

How to calculate metal weight and surface area

A part’s weight is its volume times the density of its material. For a plate that is length × width × thickness; for a round bar it is π × radius² × length. Carbon steel weighs about 0.284 lb per cubic inch, stainless about 0.289 and 6061 aluminum about 0.0975 — roughly a third of steel.

Total surface area is every face of the part: both sides, the edges and the ends. It is the number coaters, platers and painters price on, and it is easy to undercount by leaving out the edges.

Worked example: A 12 × 6 × 1/4 in carbon steel plate

Volume:
18.00 in³
Density (A36 / 1018):
0.284 lb/in³
Weight:
5.11 lb (2.32 kg)
Surface area:
153.0 in²

The edges add 9 in² to the 144 in² of the two faces. The same plate in 304 stainless weighs 5.20 lb.

  • A 2 in carbon steel round bar 12 in long weighs 10.71 lb and has 81.7 in² of surface, ends included.
  • Holes take weight off but usually add surface area: the hole’s wall is often bigger than the two openings it removes.
  • Real stock has radiused corners and mill tolerances, so treat the result as an estimate within a percent or two.

Common questions

How do you calculate the weight of a steel plate?
Multiply length × width × thickness in inches to get cubic inches, then multiply by 0.284 lb/in³ for carbon steel. A 12 × 6 × 1/4 in plate is 18 in³, or 5.11 lb.
Does surface area include the edges?
Total surface area does: every face that gets coated or plated, including edges and ends. On thin sheet the edges are small, but on thick plate and bar they add up.

Calculators in Manufacturing

  • Metal weight & surface area — Weight and total surface area of a plate or round bar in common metals and plastics.
  • Part surface area — Total surface area of plate, bar, tube, angle and hex parts with holes, and the plating or coating cost of a lot.